Menu

Odessa Fire Department History

Established in 1927

header photo

Fire Research & Development Center

          Because serious fires may occur in the oil and gas well properties under its protection, the Odessa Fire Department has established a new Research and Development Center for training fire fighters in these special problems. This Fire Research and Development Center was located at the Ector County Coliseum where the arena is now located.
          The Training at the Center was conducted under the direction of Fire Chief Charlie Meadows and Training Chief E. W. Parker. Additional training advice was given by representatives of the cooperating oil, chemical and service companies. Fire Chief Charlie Meadows, protects municipal and industrial properties in the vicinity of the Permian Basin, near Odessa.
          Since 1949, oil companies drilling wells have used hydraulic fracturing to get the oil products out of the ground. Fracturing is a process of injecting a sand and oil mixture under pressure into an oil deposit deep in the earth, thus separating crude oil from the heavier elements of the deposit, so that it may be pumped to the surface. The sand and oil are passed through a blender which is equipped with centrifugal pumps and a proportioner. This machine adds the desired amount of sand to each gallon of oil. 
          Blender pumps produce up to 70 barrels per minute and the danger of fire is greatly intensified when a hose bursts and "live" oil contacts on ignition source.
          According to Chief Meadows, several fatalities and several millions of dollars worth of fire loss have resulted because of inadequate firefighting facilities and lack of training in fire fighting techniques.
         To provide the proper training, the Fire Research and Development Center was developed by the Department in cooperation with a number of oil and gas producing companies. Typical training was conducted at the training center recently during and intensive five-day program. Firefighters and service company personnel had opportunity to take part in practical combat of fires involving natural gas and flammable liquids under a variety of fire conditions.

 

There were seven "problems," each of which was handled in a number of fire attack tests. Accurate measurements were made of the time required to control each fire.     

As the fires varied in size and complexity, fire fighters learned the application and limitations of various fire fighting methods and facilities for various kinds of fire. They also learned how groups of fire fighters are organized in combating large scale oil fires as a team.     

A description of each training problem is located below.

Problem #1      Featured a "Christmas Tree" into which natural gas is supplied through a 2 1/2 inch pipe under 100 to 160 pounds of pressure. The gas escapes through loose flanges and open ends and is allowed to "pre-burn" for approximately 45 seconds; then the trainees begin their fire attack. Altogether, six methods of extinguishment were used on this particular problem.

Problem #2      This circular pit, 75 feet in diameter, contained 9,000 gallons of crude oil with "no water cushion" Test fires were allowed to "pre-burn" for 60 seconds.

Problem #3      This consisted of a series of fires in a 15 by 35 foot pit using good, live crude oil. Test fires were allowed to "pre-burn"  45 seconds.

Problem #4      Pit fires are created in an 18 by 40 foot pit with 1600 gallons of live crude oil. Test fires were allowed to "pre-burn" 45 seconds.

Problem #5      This is a 500 barrel tank in a 36 foot diameter pit with oil spilling from the tank. Test fires were allowed to "pre-burn" 60 seconds.

Problem #6      A typical "fracture" is created in an oval pit 60 feet in length and 45 feet in width. Usually six or seven old automobiles and a 100 barrel fracture oil tank is involved. A 2 inch pipe with 10 perforations runs through the cars at the center of the pit. A "rupture" is created, allowing 144 gpm to escape under 150 pounds pressure. The oil sprayed on the cars and the tank, with the pressure supplied by a pump truck located at a safe distance. Two types of test are conducted: stopping pressures from the pump truck as soon as the fire began, then allowed 30 seconds "pre-burn". In the second test, the oil is pumped continuously and a 60 second "pre-burn" was allowed.

Problem #7      This was a irregularly shaped ditch, approximately 66 feet in overall length. Fire was created with natural gas escaping from a 2 inch pipe under 160 pounds pressure.

The following methods of extinguishment were used:
          1. Plain water Fog (low pressure)
          2. Wet water Fog (low pressure)
          3. Dry Chemical
          4. Foam - Powder and Liquid
          5. Fog Foam
          6. High Pressure Fog
          7. Soaps and Detergents
          8. Small Hand Extinguishers
          9. Applicators
          10. Aerated Wet Water